GeometryCreationUtilitiesCreateSweptBlendGeometry(Curve, IListDouble, IListCurveLoop, IListICollectionVertexPair, SolidOptions) Method

public static Solid CreateSweptBlendGeometry(
	Curve pathCurve,
	IList<double> pathParams,
	IList<CurveLoop> profileLoops,
	IList<ICollection<VertexPair>> vertexPairs,
	SolidOptions solidOptions
)

Public Shared Function CreateSweptBlendGeometry ( 
	pathCurve As Curve,
	pathParams As IList(Of Double),
	profileLoops As IList(Of CurveLoop),
	vertexPairs As IList(Of ICollection(Of VertexPair)),
	solidOptions As SolidOptions
) As Solid

public:
static Solid^ CreateSweptBlendGeometry(
	Curve^ pathCurve, 
	IList<double>^ pathParams, 
	IList<CurveLoop^>^ profileLoops, 
	IList<ICollection<VertexPair^>^>^ vertexPairs, 
	SolidOptions^ solidOptions
)

static member CreateSweptBlendGeometry : 
        pathCurve : Curve * 
        pathParams : IList<float> * 
        profileLoops : IList<CurveLoop> * 
        vertexPairs : IList<ICollection<VertexPair>> * 
        solidOptions : SolidOptions -> Solid 

Parameters

pathCurve  Curve

The sweep path, consisting of a single bounded, open curve.

pathParams  IListDouble

An increasing sequence of parameters along the path curve (lying within the curve's bounds). These parameters specify the locations of the planes orthogonal to the path that contain the profile loops. This array must have the same size as the input array "profileLoops".

profileLoops  IListCurveLoop

Closed, planar curve loops arrayed along the path. No loop may contain just one closed curve - split such loops into two or more curves beforehand. The solid will have these profiles as cross-sections at the points specified by the input pathParams. The solid will blend smoothly between the profiles. This array must have the same size as the input array "pathParams", and each profile loop must lie in the plane orthogonal to the path at the point specified by the corresponding entry in the input array "pathParams". Each profile loop must define a single planar domain and must be free of intersections and degeneracies. No orientation conditions on the loops are imposed.

vertexPairs  IListICollectionVertexPair

This input specifies how adjacent profile loops should be connected. It must contain one less element than the "profileLoops" input, and entry vertexPairs[idx] specifies how profileLoops[idx] and profileLoops[idx+1] should be connected (indexing starts at 0).

solidOptions  SolidOptions

The optional information to control the properties of the Solid.

Return Value

Reference