This class represents the MEP design to fabrication part convert tool.

This class represents the fabrication part change service and change size tools.

General utility placement methods in the Autodesk Revit MEP product for fabrication.

Class to hold fabrication part routing start or end information.

This class represents the fabrication part size map for straights allowing the sizes to be changed from a user interface for multiple straights with diffent sizes.

Options for FabricationPart.SaveAsFabricationJob() method.

General utility methods in the Autodesk Revit MEP product for fabrication.

Possible results from invoking the DesignToFabricationConverter.

An enumerated type listing all fabrication ancillary types.

An enumerated type describing where an ancillary is used on a fabrication part.

An enumerated type listing all fabrication custom data value types.

Possible results from invoking the FabricationNetworkChangeService.

Fabrication Part Comparison Types

Fabrication part stretch/fill result.

Fabrication part eccentric justifications for alignment for flat edged parts.

Possible results of the partial failure from invoking the DesignToFabricationConverter.

Lists the validation type of the fabrication part.