AdjustCurve is too short.

AdjustEdge is too short.

AdjustEdge is too short - continuable error version.

AdjustEdge is too short.

Beam and Slab Analytical Models do not have the same Analytical Projection Plane.

Distance between Analytical and Physical Models of Structural Element is beyond tolerance of [Value]

Detected physical connection between Structural Elements, but did not detect Analytical intersection.

Analitycal Link is invalid. Reference nodes have been joined.

Analytical Link has lost one or more references.

Possible Member Instability, based on Release Conditions

Possible Model Instability

Analytical Model is not created for the structural element.

Analytical / Physical Model Consistency check is complete.

Circular support chain detected

Analytical Top Projection Plane is partially or completely below Analytical Bottom Projection Plane. Please reset top and/or bottom planes to valid values.

Analytical Model for Structural Element has reset to its default location.

Boundary lines intersect.

Cannot construct Analytical Geometry.

Analytical model Adjustment distance exceeds current Adjustment Snapping Distance. To adjust snap settings, go to the Structural Settings Dialog.

Cannot construct Analytical Geometry.

Cannot slant a wall with an Analytical Model. Please disable the Analytical Model first.

Reactions defined as Internal Load (Is Reaction) may no longer be valid since the analytical model has changed.

Projection plane becomes invalid for this wall.

Can't project Analytical Model. Planes do not intersect each other.

Can't project Analytical Model. Two or more projection planes are parallel.

Can't project Analytical Model to Analytical Projection Surface

Structural Element may not be supported -- verify support for Element.

Can't align Analytical Model with joined Walls.

Can't convert Edges to Analytical Model curves.

Member support check is complete. No unsupported elements detected.

Wall Analytical Model has lost its adjustment reference.