Provides a container of all Revit built-in FailureDefinitionId instances.
The BuiltInFailures..::..PipingFailures type exposes the following members.
Properties
| Name | Description | |
|---|---|---|
  | CannotCreateGeometryForPipe |
Cannot create geometry for flex pipe. The flex pipe is intersecting itself or the start and end are too close together.
|
| CircularLoopInPipeSizing |
Circular loop detected during pipe sizing. The loop may be avoided by modifying segment settings in the pipe routing preference.
|
| DuctPipeModified |
The duct/pipe has been modified to be in the opposite direction causing the connections to be invalid.
|
| DuctPipeSizeMismatch |
The duct/pipe size is invalid for the service definition
|
| FabFittingFailed |
The Fabrication Fitting was invalid
|
| InvalidPipeSize |
Pipe Size Table "[File Name]" is missing or invalid.
|
| MaxPipeSizeReached |
Maximum pipe size diameter reached during sizing
|
| PartNotFoundDueToNoPipeConnectedError |
"In order to find a matching part, the fitting has to be connected to a pipe."
|
| PartNotFoundDueToNoPipeConnectedWarning |
"In order to find a matching part, the fitting has to be connected to a pipe."
|
| PartNotFoundInRoutingPreferenceError |
"%1s is not found. Please review the routing preference of %2s."
|
| PartNotFoundInRoutingPreferenceWarning |
"%1s is not found. Please review the routing preference of %2s."
|
