Creates a new placeholder duct.
Namespace: Autodesk.Revit.DB.MechanicalAssembly: RevitAPI (in RevitAPI.dll) Version: 21.0.0.0 (21.1.1.109)
Since: 2014
Syntax
C# |
---|
public static Duct CreatePlaceholder( Document document, ElementId systemTypeId, ElementId ductTypeId, ElementId levelId, XYZ startPoint, XYZ endPoint ) |
Visual Basic |
---|
Public Shared Function CreatePlaceholder ( _ document As Document, _ systemTypeId As ElementId, _ ductTypeId As ElementId, _ levelId As ElementId, _ startPoint As XYZ, _ endPoint As XYZ _ ) As Duct |
Visual C++ |
---|
public: static Duct^ CreatePlaceholder( Document^ document, ElementId^ systemTypeId, ElementId^ ductTypeId, ElementId^ levelId, XYZ^ startPoint, XYZ^ endPoint ) |
Parameters
- document
- Type: Autodesk.Revit.DB..::..Document
The document.
- systemTypeId
- Type: Autodesk.Revit.DB..::..ElementId
The id of the HVAC system type.
- ductTypeId
- Type: Autodesk.Revit.DB..::..ElementId
The id of the duct type.
- levelId
- Type: Autodesk.Revit.DB..::..ElementId
The level id for the duct.
- startPoint
- Type: Autodesk.Revit.DB..::..XYZ
The first point of the placeholder line.
- endPoint
- Type: Autodesk.Revit.DB..::..XYZ
The second point of the placeholder line.
Return Value
The created placeholder duct.
Exceptions
Exception | Condition |
---|---|
Autodesk.Revit.Exceptions..::..ArgumentException | The systemTypeId is not valid HVAC system type. -or- The duct type ductTypeId is not valid duct type. -or- The ElementId levelId is not a Level. -or- The points of startPoint and endPoint are too close: for MEPCurve, the minimum length is 1/10 inch. |
Autodesk.Revit.Exceptions..::..ArgumentNullException | A non-optional argument was NULL |
Autodesk.Revit.Exceptions..::..DisabledDisciplineException | None of the following disciplines is enabled: Mechanical Electrical Piping. |